Course NC- 84DSIP

Course NC-84DSIP: Commissioning and service SINUMERIK 810 D /840 D

Course  NC-DSIP developed for service specialists, adjuster and project electroautomatics developers.

Needed basic knowledge in the compilation of PLC for the successful development of course materials NC-84DSIP  - program for controller SIMATIC S7-300 as part of the course ST-7PRO1. After getting acquainted this training course participants will have the basic knowledge needed to successfully launch the SINUMERIK 810 D / 840 D, and  holding a qualified service.

The key points of the course NC-84DSIP, on which directs special attention are:

  • Overview of the main system components SINUMERIK 840 D ;
  • Management and data areas;
  • Full saving data and reloading data sets;
  • Error analysis;
  • Machine data (MD) for configuration CNC and drives;
  • Explanation of  CNC functions and its adaptation to the machine via MD and interface signals;
  • Optimization actuators and putting into operation of the machine-tool;
  • Structure of NC / PLC-interface and interface signals;
  • Basic program for PLC, PLC functions;
  • Structure of user PLC - programs;
  • Commissioning integrated controller SIMATIC S7-300;
  • Upgrade software versions;

Practical classes on commissioning and error detection at the educational stands , equipped with digital drives supply and the drive spindle.

Course duration — 5 days.

Закрыть
Ваше имя
Контактный телефон
Удобное время звонка
:
Тема общения
Введите код с картинки